Forum: F-16 Design & Construction

I'm looking for a diagram that details how the MFD bezels are put together and wired up? Basically what layers there are, how the switches are retained, all that good stuff. Again, this is for the MFDs I'm making for this Block 60 home simpit.

F-16.net Sponsor

Kept together by some tape, glue, spit and hard work Smile

I thought it was magic and gnomes or is that MLU only?

Kaasjager. wrote:

I thought it was magic and gnomes or is that MLU only?

I believe those were retired last year, only the ones with tape, glue, spit and hard work are still flying Wink

The bezel assembly with all the OSS and rocker switches unscrews from the CRT then there is a ribbon cable with a small wafer type connector and tiny screws that connects the bezel to the crt.....I only know this because durring the NVIS mods we had an issue with supply. Supply needed a DIFM for a NVIS MFD and we had a Non NVIS MFD. So a trip to depot where we able to aqquire a NVIS bezel and little "flight line surgery" and like magic we had a NVIS mfd. The supply troop knew we did something shady but she took it anyways. She didn't like the fact that you couldn't read the dash number. She also didn't like that a write up for a display problem all of a sudden had additional problems of OSS's or rockers switches INOP........I told you those screws on the wafer were really tiny! haha good times!

Forum: F-16 Design & Construction

MFD Assembly Diagram?