- Posts: 27
- Joined: 20 Jun 2009, 10:40
VarkVet wrote:"Im assuming your talking about external ground power App.
Take switch from Maint to Norm and do pinch-pull FLCS reset ... CADC light will go out
Don't run external power without cooling air in Norm
T.O.s are online now ... get a CAC card reader, set up at home, and read them at home to enhance your knowledge!
BouliNDSO wrote:Total temp sensor fail, CADC bit fail, AOA fail, Baro Altimeter input fail, you name it. Just check the T.O.'s
koraydemir wrote:check the cadc to engine wiring. cadc sends mach signal to engine any short to ground would illunumate the caution!
Users browsing this forum: No registered users and 0 guests