Page 1 of 1

Airbrush Issues

Unread postPosted: 06 May 2009, 14:23
by proudpop
I finally purchased a Badger Anthem 155 dual action airbrush for projects like the Tamiya 1/48 "AK" aggressor-but it oversprays like he@#! Especially the extremely light gray/flat black demarcation lines
I finally went back to my old school Badger 100 series gun to get it right, with many touch ups. I thought the 155 would give me the performance to make those tight contrasting lines on 1/48 scale aircraft? I tried adjusting the paint/thinner ratio with no luck. Will a finer needle help? Am I screwing up? Help! :?

RE: Airbrush Issues

Unread postPosted: 21 May 2009, 17:02
by proudpop
Huh? No responses so far. I thought that someone in this forum would know more about this! Come on! Help me out! :bang:

Unread postPosted: 22 May 2009, 20:50
by jefropas
Stop scaring me, I just bought one a few months ago and haven't used it yet. Its my first new airbrush in about 20 years. I have this exact same project on the books and I'm concerned. Thanks for the heads up!


Unread postPosted: 04 Jun 2009, 22:11
by Habu
Sorry, I just haven't had much time to get on here. Just clean it very good. Give it a D-level disassembly and clean everything. But as far as camo goes, I'd use paper and tac worm masks, not freehand.