Photos of pilot touching the wing or inlet
- Elite 1K
- Posts: 1101
- Joined: 25 Dec 2015, 12:43
spazsinbad wrote:How tall are these guys?
Thank you spazsinbad, but that isn't exactly what I am looking for.
Sorry for not making myself clear.
Do you see the slight off colour paint at the inlet and wing edge? I wanted to estimate the size of those paint strip, so a side view photo is what I am looking for
- Elite 1K
- Posts: 1557
- Joined: 01 May 2017, 09:07
garrya wrote:Does anyone have a photo of pilots (or human in general) touching the inlet or the wing of F-35? So as to show the relative size
Like below but with the inlet or the wing
The wing tip is reachable.
And intake touched by a pilot
https://www.dvidshub.net/image/4707010/ ... f-35-pilot
- Enthusiast
- Posts: 91
- Joined: 16 Aug 2008, 00:30
I am assuming you are doing some type of modeling. Same here. I don't know what you already have but these are just net pics from a few years ago. I scaled up a full side view pic in a 3d program then ran the dimension tool on the area you were asking about.
Good luck.
- Elite 1K
- Posts: 1101
- Joined: 25 Dec 2015, 12:43
BELA wrote:
I am assuming you are doing some type of modeling. Same here. I don't know what you already have but these are just net pics from a few years ago. I scaled up a full side view pic in a 3d program then ran the dimension tool on the area you were asking about.
Good luck.
Thank you,however, I'm not doing modeling
I'm trying to estimate the lowest frequency where the edge treatment of F-35 can remain effective.
The minimum required width is about half a wavelength
10 posts
|Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests